National Alloy Assembly Instruction

Lay out pieces on the ground and locate mounting hardware supplied.
1
(Figure A)
Figure A:
Place and install the lower base spacer piece to both side pieces and
2
secure with eight (8) Self-Tapping Screws. Four (4) screws used on front
face and four (4) screws used on back face. (Figure B)
Note: If applicable make sure that both electrical pass through
holes are in alignment with each other and biased towards the
bottom base spacer. (See figure A for reference)
Figure B:
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
Electrical Pass Through
Lower Base Spacer
Assembly Instruction
Top Spacer
Side Piece
800.482.1717
Alloy
Vertical Storage
Spacer Assembly
Package Contents
Item
M5.5–1.8 X 13MM
ZINC PL PHIL/SQ COMBO
#8 X 3/4" PHILLIPS
SELF TAPPING SCREW
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
Part # 3111376
Rev, -
Printed in U.S.A
© 2018 Kimball International, Inc.
.
Qty
24
6