National LOCHLYN Assembly Instruction

1
THIS MODULE IS ASSEMBLED WITH A HIDDEN
FASTENER HARDWARE SYSTEM THAT COMES
PREINSTALLED. ONE OF THESE, THE CHANNEL LOCK
FASTENER, IS THE FEATURED IN THIS ASSEMBLY
(FIGURE A). IF PANELS APPEAR TO BE MISSING
FASTENERS OR THEY ARE DAMAGED, CONTACT
CUSTOMER SERVICE FOR REPLACEMENTS.
2
RETREIEVE END PANEL AND STAND IT UP SO THAT THE
FRONT EDGE IS ON THE GROUND AND THE THRU HOLES
IN THE CORNERS ARE ON TOP (FIGURE B). NOTE THE ROUTED
PROFILES (FIGURE C) ON THE END PANEL AND THE
DIRECTION OF THE SMALLER ROUT COMPARED TO THE
CLEARANCE SLOT. THE SMALLER ROUT IS THE CAPTURE
PROFILE THAT WILL HOLD AND POSITION THE CHANNEL
LOCK.
FIGURE C
3
RETREIVE THE TOP PANEL, THAT HAS TWO SETS OF PILOT HOLES, AND START THE
PANEL INTO THE FIRST SET OF ROUTED PROFILES (FIGURE D). SLIDE OVER TO LOCK
IT INTO THE END PANEL (FIGURE E).
NOTE: END PANEL ROUTED CUTS ARE SYMMETRIC AND DOESN'T HAVE A SET TOP OR
BOTTOM TO INSTALL THE TOP PANEL. USE GRAIN DIRECTION OF THE PANEL TO
DETERMINE WHICH SIDE SHOULD BE THE TOP.
NOTE: ENSURE TOP PANEL PILOT HOLES ARE FACING OUT AWAY FROM THE INTERIOR OF
THE BOX, NOT TOWARDS THE INSIDE. CORRECT IF NECESSARY AT THIS POINT.
FIGURE D
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
Assembly Instruction
FIGURE A
FIGURE B
FIGURE E
800.482.1717
LOCHLYN MODULE
PASS THRU
TOOLS REQUIRED
DRILL DRIVER W/ PHILLIPS BIT
HARDWARE
#8X5/8" PAN HEAD SCREWS
#8X1 1/8" FLAT HEAD SCREWS
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
3249051,-
Rev, -
.
QTY X4
QTY X4