National TESSERA HGT. ADJ. DESK Assembly Instruction

1

Unpack the desk and set into position.

2
Remove two flat brackets from the bottom of each shroud to access the interior as
needed. Brackets can be discarded (Figure B) as they are only installed to protect
during shipping.
NOTE: Removable panel hangs from Z-clip brackets. Once flat brackets are
removed care should be taken so that the panel does not disengage from Z-clip
and damage the component.
3
Install glides (Qty. 4 per shroud) supplied in hardware kit to underside of each
shroud (Figure C)
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
Figure A
Figure B
Figure C
Assembly Instruction
TESSERA HGT. ADJ.
DESK

Tools Required

-Screw Driver w/ #2 Phillips Bit
-Level
-Cable ties

Hardware

-Glides
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
3206401
Rev, -
.
800.482.1717
x8