National LOCHLYN CORNICE TOP Assembly Instruction

1
UNPACK AND POSITION THE TOP OVER THE FRAME (FIGURE A). SQUARE THE TOP
TO THE FRAME THEN CLAMP DOWN LIGHTLY WITH A NON MARRING CLAMP.
2
RETRIEVE THE ANGLED BRACKETS AND SCREWS FROM THE HARDWARE KIT. THE
BRACKETS WILL BE ATTACHED TO THE DEPTH CROSS MEMBERS ALONG THE FRAME
WITH SELF TAPPING SCREWS AND TO THE TOP WITH STANDARD PAN HEAD SCREWS.
POSITION ONE OF THE BRACKETS APPROX. 2" INSIDE THE HORIZONTAL RAIL TO CLEAR
THE JUNCTION BLOCK (FIGURE B). START AND RUN DOWN THE 1" PAN HEAD SCREW TO
MOUNT IT TO THE WORKSURFACE.
NOTE: ENSURE THE SHORT ARM OF THE BRACKET IS ALONG THE FRAME AND THE LONG
SIDE TO THE WORKSURFACE.
TIP: USE MASKING TAPE AND APPLY A STRIP TO HOLD THE BRACKET TO THE FRAME AND
ANOTHER STRIP TO THE WORKSURFACE. THIS HOLDS THE BRACKET IN POSITION DURING
INSTALLATION AND FREES UP A HAND.
FIGURE B
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
FIGURE A
Assembly Instruction
LOCHLYN
CORNICE TOP
TOOLS REQUIRED
DRILL DRIVER W/#2 PHILLIPS BIT
NON MARRING CLAMPS
MASKING TAPE
HARDWARE
BRACKETS
#8X1" PAN HEAD SCREWS
#8X5/8" SELF TAPPING SCREW
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
3249055
Rev, -
.
800.482.1717
QTY VARIES
QTY VARIES
QTY VARIES