Autoprint Pc; Remote Control; Description Of The Data Transfer - KERN 572 Operating Instructions Manual

5.4.4 AUTOPRINT PC

The setting AUTPRINT PC is in the PRINTER-routine, and there it can be selected or
deselected. When AUTOPRINT PC is active the actual weighing values will be sent
continuously via the RS 232 interface.

5.4.5 Remote Control:

The following functions can be released by the remote controls that will be transferred as
ASCII signs to the balance.
t Tare.
w a weighing value (or unstable) is sent via RS 232 interface.
s a stable weighing value is sent via RS 232 interface.
If the balance receives the command w or s, it acts without printing delay.

5.4.6 Description of the data transfer:

Structure of each data transfer:
Without Numerator:
Bit-Nr. 1 2
B
B*
B*: =
.
B, 0, , g: =
CR: =
LF: =
With Enumerator:
Bit.Nr. 1 2 3
N N N B* B
N: = Enumerator
572/KB/DS-BA-defsi-0246
3 4 5 6
B B B B
Blank or % in the range of zero point.
Blank or weighing value with unit, depending on the load on the
weighing plate.
Carriage Return
Line Feed
4 5 6 7
B B
7 8 9 10 11 12 13 14 15 16 17 18
B B B 0
8 9 10 11 12 13 14 15 16 17 18 19 20
B B B B 0
.
0 B g B
.
0 B G
B CR LF
B B CR LF
37