The Enumerator; The "Fast" Setting For Fast Weighing - KERN 572 Operating Instructions Manual

4.10.3 The Enumerator

The enumerator counts the weighing if a printer is connected. All printed weighing are
continuously enumerated.
Select/Deselect "Enumerator"
1. Press MODE-key repeatedly until display shows.
2. Press YES-key.
3. Press Mode-key repeatedly until the balance displays.
4. Press NO to deselect the enumerator.
Press YES to select the enumerator.
5. Press MODE-key repeatedly until the balance displays in
grams again, or press TARE-key.
Reset the enumerator to 000:
Reset the "Enumerator"
1. Press MODE-key.
2. Press YES-key.

4.10.4 The "Fast" setting for fast weighing

The balances can be adjusted to their location in stages from 1 – 5
Stage 1
Stage 5
Volumetric weighing requires a high display speed. This can be set using the "Fast"
option in the MODE programme.
Select/Deselect "Fast"
1. Press MODE-key repeatedly until display shows:
2. Increase Fast with the YES key, decrease Fast with the NO
key.
3. Press MODE-key repeatedly until the display shows grams
again, or press TARE-key.
34
= good location condition,
= poor location conditions, slow display
fast display
572/KB/DS-BA-defsi-0246
Display
Printer?
1200 Bd.
Numerator?
Numerator?
Numerator?X
0,0g
CLEAR?
0,0 g
Display
Fast?X
Fast1
Fast5
0,0 g