Cleaning Surfaces With The Hydropower Ro / Normal Operation; Interruption Of Work - unGer Hydro Power RO System RO40C Operating Instructions Manual

Operation of the HydroPower RO
Cleaning surfaces with the HydroPower RO
5.5 Cleaning surfaces with the HydroPower RO
The HydroPower RO has three water outlets so that 3 people can work in parallel.
The water pressure is distributed over the 3 outlets and depends on the hose length or hose diameter
used.
We recommend regulating the water pressure between the 3 hoses, especially with height differences,
with a valve. For example the UNGER hose connection # 18330 incl. water switch or the UNGER
HiFloControl # TMOOV, regulate the water quantity at the water fed pole.
Water output
of the connectors
max.
5.6

Interruption of work

If you need to interrupt your work with the HydroPower RO, proceed as follows:
1. Stop the HydroPower RO by pressing the STOP button.
Leave the on / off knob in the current position.
2. To resume the work, turn the on / off knob to the green position and then to the centre position. If
the on / off knob is already in the green position, slightly turn it to the left and then back to the green
position.
The HydroPower RO is restarted and ready for use immediately. The self-cleaning process is skipped
3
when the HydroPower RO is restarted within an hour.
Note that the right water connection receives more water from the
membranes than the middle or the left.Therefore, long hoses or higher
poles should be connected to the right water output.
NOTE
The longer the hose from the water outlet to the water fed pole, the larger
the diameter of the hose should be.
www.ungerglobal.com
Quality Tools for Smart Cleaning
23