Table of Contents
Advertisement
4.3.2
Storage
If the unit is not in use for more than 7 days, the membranes must be protected according to the storage
instructions, see chapter „7.2.4 Membrane protection".
4.3.3
Operating the HydroPower RO
1 2
Flow of water purification
The water enters the HydroPower RO via the water inlet (item 5).
The carbon/sediment combi pre-filter (item 1), which filters out the largest impurities and chlorine from
the water and thus protects the membranes, sits before the membranes.
The 2 membrane filters (items 2, 3) remove up to 98% of the minerals from the water in the HydroPower
RO.
The resin filter (item 4) sits after the membranes, which removes the last 2% of the minerals from the
water in the HydroPower RO.
Pure water is discharged from the 3 water outlets (item 5) into a hose connected to a water fed pole for
cleaning glass surfaces without chemicals.
The 4 filter cartridges (items 1 - 4) can be easily removed and replaced. The status and the current
performance values can be checked via the display and pressing the corresponding buttons.
The measurement of the filter performance is set for maximum economic efficiency. If, for example, you
fail to change the RO membrane, the resin in the resin filter will require frequent replacement, increasing
your maintenance costs.
The measured values in the device are calculated for a consumption period of 12 months. As soon as the
filter performance of the membrane decreases, the resin consumption increases slowly, since higher
ppm values now arrive at the resin filter. If the exchange of the membranes is then more favorable than a
continuous change of the resin cartridge, the device recommends a membrane change.
Preparing for use
Transport and storage
1
Carbon/sediment combi pre-filter
2
RO membrane 1
3
RO membrane 2
3
4
DI resin filter
5
Water inlet
4
6
3 x water outlet
5
6
www.ungerglobal.com
Quality Tools for Smart Cleaning
17
Advertisement
Table of Contents
