Related Manuals for J-Tech Digital NA-EX01R
Summary of Contents for J-Tech Digital NA-EX01R
- Page 1 Operating Instructions Website: www.jtechdigital.com Toll Free: 1-888-610-2818[US] Email: Support@jtechdigital.com NexAV HDBaseT 4K@60Hz HDMI Extender Receiver 70M/40M NA-6001...
- Page 2 The HDBaseT HDMI Extender Receiver Control Path has been tested for conformity to safety regulations and requirements, and has been certified for international use. However, like all electronic equipment, the NA-EX01R should be used with care. Please read and follow the safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit.
-
Page 3: Table Of Contents
TABLE OF CONTENTS INTRODUCTION ....................... 1 PACKAGE LIST ......................1 FEATURES........................ 1 PANEL DESCRIPTION ..................... 2 SYSTEM CONNECTION ................... 3 SYSTEM CONNECTION ................... 4 SPECIFICATION ....................... 5 PANEL DRAWING ....................6 TROUBLESHOOTING & MAINTENANCE ..............7... -
Page 4: Introduction
INTRODUCTION The NA-EX01R is a 4K HDBaseT Receiver to receive 1080p/4K HDMI signal over CAT5e/CAT6a cable from HDBaseT Transmitter or Matrix Switcher up to 70m /40m (PoH), and enables IR and RS232 pass-through to control source or display device remotely. It also supports CEC. -
Page 5: Panel Description
PANEL DESCRIPTION Name Description HDBT Link status indicator: OFF: No Link. ① LINK LED GREEN: Link successful. Blinking GREEN: Link abnormal. HDCP compliant indicator OFF: No HDMI traffic (no picture). ② HDCP LED GREEN: Traffic with HDCP. ... -
Page 6: System Connection
All of the power switches, plugs, sockets and power cords should be insulated and safe. All devices should be connected before power on. HDMI: 4K 40m RS232: HDBaseT: 1080P 70m Transmitter NA-EX01R Receiver IR Receiver IR Emitter Projector Remote Laptop Projector... -
Page 7: System Connection
SYSTEM CONNECTION Connection Procedure Step1. Connect HDMI source (such as Blue-ray DVD) to HDMI IN port of transmitter with HDMI cable. Step2. Connect HDBT OUT port of transmitter and HDBT IN port of receiver, with single CAT5e/CAT6a cable. Step3. Connect HDMI displayer (such as HDTV) to HDMI OUT port of receiver with HDMI cable. -
Page 8: Specification
SPECIFICATION Input & Output Input (1) IR; (1) HDBaseT; (1) RS232 (1) 3.5mm mini jack; (1) RJ-45; Input Connector (1) 3-pin pluggable terminal block Audio Digital audio, transmit through HDMI audio Output (1) HDMI; (1) IR; (1) RS232 (1) Female HDMI; (1) 3.5mm mini jack; Output Connector (1) 3-pin pluggable terminal block General... -
Page 9: Panel Drawing
PANEL DRAWING LINK HDCP RS232 IR IN IR OUT HDMI OUT HDBT IN DC 24V 115 mm... -
Page 10: Troubleshooting & Maintenance
TROUBLESHOOTING & MAINTENANCE No image on display: Ensure that the display device has been set to the correct input. Ensure that the HDMI cables used for both the source/transmitter and the receiver/display are properly connected and are working. Test the HDMI cables directly from a source to display and ensure their operation. - Page 12 Product pictures are for reference only. Specifications described herein are subject to change without prior notification. All trademarks are the sole property of their respective companies. Copyright © J-Tech Digital, Inc. All rights reserved.