Advantech HIT-W101C Quick Start Manual

HIT-W101C Quick Start Manual
(1) HIT-W101C Appearance
Front-view
* Please use the wall mount bracket only.
Follow below pic to match the mount and HIT-W101C, and use the
screw to fix it from the bottom side
Screw Type: M2.5 x 8mm
The drawings and specifications in this document are property of Advantech and may not be reproduced. copied or used without prior written permission.
(2) Packing List
1)
HIT-W101C x1
2)
Accessory box
This quick start manual x1
Wall Mount Bracket x1
Self-tapping screws x4
Screw M2.5 x2
(3) Front/Rear View
Rear-view
(4) Easy Setup
Power On Computer:
1) Make sure Equipotential Terminal is connected to
equipotential ground in the hospital.
2) Connect the adapter to Power DC-IN. Please note that using
different adaptors may put the system into risk.
3) When you plug in the DC power, the HIT will power on
directly.
4) DC Input Voltage: The adapter only supply 12Vdc. Power
Consumption: less than 36W
x1
Page 1 of 2
(5) Software Specifications
Please always check Advantech website for free downloading:
http://support.advantech.com/support/new_default.aspx
(6) Cleaning and Disinfecting
During normal use, the HIT (Healthcare Information Terminal)
may become dirty and should be cleaned regularly.
1) Prepare a cleaning agent per manufacturer's instruction or
hospital protocol.
2) Prepare a clean cloth that has been moistened in a
cleaning solution.
3) Wipe the HIT thoroughly with a clean wipe.
Applicable Cleaning Agents List
No Cleaning Agents
1 CHLOR-CLEAN (1.7g NaDCC)(1000 ppm available
chlorine)
2 Alcohol, 95% concentration
3 AHP Accel TB
4 Glutaral dehyde [C5H8O2], 2% concentration
5 Isopropyl alcohol [(CH3)2CHOH], 70% concentration
6 Sodium hypochlorite [NaOCl], 10% concentration
* Do not immerse or rinse the HIT or its peripherals.
* Do not spray cleaning agents on the chassis
* Do not use disinfectants containing phenol
HIT-W101C Quick Start Manual