Advertisement
Instructions for Special Edition Kit #JM-44
Assembly Details:
Photos support the descriptions but do not replace them.
Note: Many of these photos are of un-painted parts, but you
should have painted these parts at least one-coat already,
and have sanded thoroughly.
�
3. Illustration #4 Glue and tape the Front to the Sidewall
assembly, Line up the ends of the floors with the edge of the Front.
Make sure the Base Floor is tight to the top of the groove.
4
Lined up on the edge
Will you be cutting a doorway into the house? Now is the right time to do it.
Lay out the door cutout in the Liner (usually 3
Cut the Liner with a utility knife, oscillating multitool, or jig saw.
Set the extension and Liner against the house - mark the house.
Cut the doorway in the house.
note: I extend the door frame with
�
4. Illustration #5 Glue and tape the 1st Story Liner between
the floors, flush with the ends of the Floors, tight to the front.
5
Liner
1
/
x 7
1
/
, 1" from the back).
16
16
1
/
x
1
/
stock when I install the door.
8
8
A Well Taped Corner won't slip
Let the glue dry.
page 8
Advertisement
