Advertisement
Instructions for Special Edition Kit #JM-44
Preparation
Begin by deciding whether this extension is to be used on the left or
the right side of your house. These parts may be used for either side,
but illustrations shown here describe the assembly of the left side
extension. The orientation of parts for the right side extension are
exactly reversed.
Pre-finish the woodgrain floors to protect the surface from dam-
age during construction. Wipe off the first coat of finish completely
and, when dry, gently sand the surface to take off the shine (a used
"ScotchBrite" pad is perfect), then put on a second coat of finish.
Continue to step 4 without stopping
Assembly
�
1. Illustration #2 Glue and tape the Milled Side to the Middle
Floor, flush at the back, and sticking out
�
2. Illustration #3 Glue and tape the Base Floor in place,
flush at the back, and sticking out
Make sure the Base Floor is tight to the top of the groove.
This photo is of a Left Addition
1
/
" in the front.
8
1
/
" in the front.
8
The Floors stick up
1
/
" in front
8
The Base Floor is tight to
the top of the groove
Use enough glue so some squeezes out of every joint.
Keep a damp rag and a dry rag handy to clean up excess.
From here on I do gluing and taping, then let the glue
dry with the Addition in position against the house. This
gives the best guarantee that everything will fit, but it
absolutely requires a flat worksurface that is big enough
to do all of that. If it's not flat the parts won't fit.
Assembly Instructions page 7
Advertisement
