Technical Data; Declaration Of Conformity; Device And Function Definition In Accordance With En 60730-1; Weee Directive 2012/19/Ec - Honeywell HCE80R Mounting And Operation Instructions

28
Appendix – continued

Technical data

Input/output voltage
Power consumption
Pump relay
Boiler feedback relay
Thermal actuators
Ambient temperature
Storage temperature
Humidity
Radio communication
Range
Dimensions
Weight
Fuse
Material
Degree of protection
Fire class

Declaration of conformity

Honeywell hereby declares that HCE80(R) / HCC80(R)
complies with the basic requirements and other
relevant regulations of guideline 1999/5/EC.
The declaration of conformity of the product
can be requested from the manufacturer.
!
Note for non-EU countries:
This product may only be used
if operation in the 868 MHz
frequency band is permissible.
230 V AC, 50 Hz
Max. 1750 VA with
connected pump (max. 6 A)
Switching contact
230 V AC, max. 6 A (not
floating); cos ≥ 0.7
42 V AC; 1 V < U 42 V;
1 mA < I 100 mA; cos = 1
2.7 A max. for 1 s;
200 mA; cos ≥ 0.95
0 to 50°C
-20 to +70 °C
5 to 93% relative humidity
SRD (868,0...870,0) MHz
RX Class 2
Typically 30 m, one floor
350 x 82 x 52 mm
(W x H x D)
1 kg
Ceramic fuse 5 x 20 mm,
230 V AC; 2.5 A; fast
LOW
IP30
V0
Appendix
Device and function definition in
accordance with EN 60730-1
Purpose of the device is temperature controlling
Device fulfils Protection class 1,
EN60730-1, EN60730-2-9
Independently installable electronic
control system with fixed installation
Type of action is Type 1.B (pump relay)
and Type 1.C (thermal actuator)
Temperature
for ball-thrust hardness test for housing components:
75 °C and
for live parts such as terminals: 125 °C
EMC emitted interference test at 230 V AC
+10/-15 %, 1750 VA maximum
Pollution severity is 2
Rated voltage is 4000 V (corresponding
to Overvoltage category III)

WEEE directive 2012/19/EC

Waste Electrical and Electronic Equipment directive
At the end of the product life dispose of the packaging
and product in a corresponding recycling centre.
Do not dispose of the unit with the
usual domestic refuse.
Do not burn the product.
Remove the batteries.
Dispose of the batteries according to the local statutory
requirements and not with the used domestic refuse.