Binding Room Setpoint Generators/Sensors - Honeywell HCE80R Mounting And Operation Instructions

Commissiong and binding the evohome
controller
If you want to control the room temperature with
the evohome controller (that has to be located
in this room), press YES. Otherwise press NO
and connect a sensor – either a room thermostat
(DTS92) or a room setpoint generator/sensor
(HCW82/HCF82).
Binding a room thermostat (DTS92)
Keep the
1
long to set the room thermostat to standby.
Keep the ▲ and ▼ button pressed
2
simultaneously for 3 seconds.
INst should be displayed.
Press the ▼ button.
3
COnt should be displayed.
Press the ▲ button three times.
4
CLr should be displayed.
Press the
5
existing connecting data.
Press the ▲ button.
6
COnt should be displayed.
Press the
7
send the connecting signal to
the evohome controller.
You should receive a SUCCESS
8
message at the evohome controller
(if not, go back and bind again).
1
2 SECONDS
HCE80(R) / HCC80(R) Mounting and operation
button pressed 2 seconds
button once to delete
button once to
2
3 SECONDS
Binding a room setpoint generator/
sensor (HCW82 or HCF82)
Briefly press the bind button in the bottom
1
right-hand corner. The red LED flashes.
You should receive a SUCCESS
2
message at the evohome controller
(if not, go back and bind again).
1
Binding the underfloor heating controller
with the evohome controller
Press and hold the installation
1
button
controller for 2 seconds.
The LED lights up. The LED
of zone 1 flashes green.
Press the green connection button
2
at the evohome controller.
If binding was successful, the
yellow LED of the underfloor
heating controller lights up.
Binding of the zone (room) is completed.
Repeat the process to bind further zones:
Press the bind button
controller twice (skip red flashing LED).
The green LED of the first zone flashes green.
1
on the underfloor heating
at the underfloor heating
15