Commissioning - Honeywell HCE80R Mounting And Operation Instructions

Installing an external antenna
Up to three underfloor heating controllers
can be connected to an antenna.
Only install the external antenna outside
1
metal housings (e.g. control cabinets).
Install the antenna at a suitable location near
2
the underfloor heating controller (3).
Strip the connections 5.5 mm (see
3
fold-out page, Fig. 5).
Connect the antenna (see fold-out page, Fig. 4 (9)):
1 4
Shield to Terminal 2, second conductor to Terminal 1
Close the terminals.
5
Operation with several underfloor heating controllers
If several underfloor heating controllers are operated
simultaneously, an antenna (internal or external)
may only be connected to one controller.
Closing the housing
Place the housing cover back on (see fold-out page).
1
Snap the left and right snap lock back into place.
2
Tighten the screws on the top.
3
1 4
1 2 3 4 5 6
B+ H/C TW
Antenna connection
Controller 1 Controller 2
B+ B+
HCE80(R) / HCC80(R) Mounting and operation
5
Controller 3
B+

Commissioning

During commissioning, room setpoint
generators/sensors and, if applicable, the
time programs of the central operating
devices are assigned to the temperature
zones of the underfloor heating controller.
Connect the underfloor heating
1
controller to the supply voltage.
The mains voltage LED (POWER) lights up.
LED displays at the underfloor heating controller
The LEDs on the underfloor heating controller
(see fold-out page, Fig. 3 (1, 2, 3)) indicate
the operating modes of the underfloor heating
controller and the installed temperature zones.
LED
Display
POWER (green) Lights up
Lights up
(red)
Flashing
Rapid flashing No device installed
(yellow)
In normal mode the LEDs 1...8 show the position of
the thermal actuators (see fold-out page, Fig. 3 (7)).
LEDs 1...8 Meaning
Green Thermal drive opened
Off Thermal drive closed
Meaning
Normal mode
Group alarm
Antenna fault display
13