Introduction - Honeywell HCE80R Mounting And Operation Instructions

2

Introduction

These installation and operating instructions contain all the information required for installation,
commissioning and configuring the underfloor heating controller HCE80(R) / HCC80(R).
All the operating elements and connections are shown on a fold-out page.
Fold out the left-hand cover.
1
Leave the cover folded out while reading further.
Introduction
Legend for fold-out page
Fig. 1 Scope of delivery
Fig. 2 Opening the housing
Fig. 3 Display and operating elements
Power
(1)
(2)
(3)
(4)
Mode
(5)
(6)
1...8
(7)
(8)
Fig. 4 Connections
(9) I/O
connector
(10) Switch for setting normally
open/normally closed
(11) Slot for expansion module HCS80
(12) Connector for supply voltage, pump
(13) Fuse
(14) Slot for internal antenna
(Z1...Z8) Connector for Zones 1...8
Fig. 5 I/O connector
Fig. 6 Connector for Zones 1...8
Fig. 7 Connector for supply voltage, pump
Power supply on/off
Information display
Installation display
Operating mode button
Installation button
Pump off/off display
Zone LEDs
Labelling of Zones 1...8