Table of Contents
Advertisement
SONOTRACKER SERIES MENU DESCRIPTIONS
MENU OPTIONS
The following options are available from the MENU key in manual mode:
•
10 Display: Select desired display formats, input vessel and adjust
brightness and contrast.
•
20 Calibration: System configurations including full point, or Math Menu
span and mode of operation; Math Menu for Math Channel configuration.
•
30 Relay Set Point: Configure relay set point.
•
40 I-Output: Configure Current (mA) output.
•
50 Serial/PLC: Set up serial out and PLC.
•
60 Transducer: Configure the transducer including frequency, delay and
threshold values.
•
70 Range/Filters: Set up range and filter windows.
•
90 Service Menu: Includes access configuration as well as system default
and copy function.
Figure 19: Menu Tree Diagram
10 DISPLAY
The Display Menu is used to set up the parameters that govern the display functions when channel monitoring.
This section covers the functions in the Display Menu. Explanations of each of the functions are provided.
Unless otherwise noted, the display function for each channel (such as ID) can be set differently. The
descriptions below for each function note those that are global in nature and that affect the display for all
channels.
As shown in
, the Display Menu has eight submenus.
Figure 19
SON280020 Rev. C
51
www.bindicator.com
Figure 18: Controller Menu
Access Diagram
FROM CHAPTER FOUR
01 XXKHz
XXXX XXX
Press SCAN/HOLD Key
Press MENU key
and then either
the arrow keys
to select desired
menu structure
or
type in the menu
number, i.e. 30 and
press Enter.
Advertisement
Table of Contents
