Menu Tree - Bindicator SonoTracker Ultrasonic Liquid Level Installation & Operation Manual

Can monitor up to a total of 8 transducers of various frequencies, accommodating multiple vessels of different heights and shapes.

Table of Contents

SonoTracker Series

10 Display

3. Scroll with the arrow keys to the 90 Service Menu option. Press Enter. The display shows:

Service Menu

91 Access

4. Press Enter. Then select User, press Enter. Use the keypad to enter a one-, two-, three-, or four-digit

number. Press the Enter Key when done entering the number. The display flashes a message

acknowledging the entry and returns.

Note: Record the access code and store it in a safe place. If misplaced, call Bindicator for instructions

to bypass the code.

Once the number is entered, you have access to all functions and hidden menus that require the code,

while you remain within the Manual Mode (i.e. you will only need to enter the code one time per Manual

Mode session, regardless of the number of functions and channels you access). The supervisor Mfg

Code (see below) has precedence over the Bindicator Service Code (same as Mfg Code). If you enter the

Mfg Code in the Bindicator function under the Access Menu, the SonoTracker Series controller will not

require you to enter the Bindicator Service Code when you change values in the Service Menu.

5. Press the Esc Key to scroll up the menu tree or the Scan/Hold Key to return the display to vessel

monitoring. The Access Code is 'activated' when you leave the Manual Mode. Upon returning to the

Manual Mode and reentering the menu tree, you will be prompted to enter the code if you attempt to

change a system parameter. But, you will be prompted to enter the code only the first time you attempt

to change a system parameter within one Manual Mode session (i.e., you will only need to enter the

code one time per Manual Mode session, regardless of the number of parameters you change and

channels you access).

BINDICATOR

The SonoTracker Series has two factory code numbers. Certain troubleshooting functions require one of these

code numbers be entered before access to the function is permitted. The Service Code, described earlier in this

chapter, is entered when prompted by the display and is the same as Bindicator Mfg Code. The Mfg Code is

entered when in the Access Menu, as described below:

SON280020 Rev. C

BINDICATOR MFG CODE

The Bindicator Mfg Code is required to access hidden

menus, which are typically only used by Bindicator

Meters personnel for troubleshooting and testing the

equipment. The Bindicator Mfg Code number is:

9111

www.bindicator.com

on how

Table of Contents