Table of Contents
Advertisement
based on the transducer's maximum range, before it transmits the next signal, regardless of how quickly
the previous signal was returned. MaxRange is the default and recommended setting for End Range.
•
Target — if the transducer detects a target closer than the maximum range (i.e., the total time to transmit
and receive the signal is less than the prescribed time), the transducer sends out the next signal, rather
than waiting until the prescribed time has elapsed.
79 DELAY OFFSET (CONSULT BINDICATOR BEFORE MODIFYING!)
Delay Off is a parameter related to the operating frequency of the transducers. It sets the propagational delay
for the electronic circuitry. Not that a change made to Delay Offset for a particular type of transducer affects all
channels that are monitoring that type of transducer. For example, if you modify Delay Offset for a 56T-25, all
channels that are using 56T-25 will use the new Delay Offset value.
90 SERVICE MENU
Figure 27: Service Menu Tree
91 ACCESS
The Access menu allows you to:
•
Set a user-defined access code
•
Input the Bindicator Mfg Code, which is needed when performing certain troubleshooting functions.
Access has two submenus: User and Bindicator
USER
The SonoTracker Series arrives from the factory without a user-defined access code in place, allowing the
user to access any function (other than those requiring the Bindicator Mfg Code or Bindicator Service Code)
in the system at will. The User function allows you to set up a code to limit access to changing most system
parameters (i.e., display parameters, setpoint parameters, calibration parameters, etc.). Once a User Code is
in place and activated, your operator(s) will be able to go into the menu tree to view parameters, but will not be
able to change parameters without entering the code. Follow this procedure to set up an access code:
1. If the controller is in Auto Mode (Auto LED illuminated), press the Scan/Hold Key to put the system in
Manual Mode. The Auto LED turns off.
2. Press the Menu Key to display the Main Menu. The display shows:
70
www.bindicator.com
SON280020 Rev. C
Advertisement
Table of Contents
