Table of Contents
Advertisement
Note: The Sensor Key only works if you are at the "end" of a menu; i.e., where the screen allows you to enter a
value or select from a list of choices on the display. If you press the Sensor Key, the display changes to:
'Enter' to Copy
> 25.0 ft
Press the Up/Down Arrow Keys to switch to the previous channel (ID#01). When the display shows the desired
channel, press the Enter Key. For Next and Back, the controller display actually switches to the menu tree for the
selected channel.
If you do not want to switch channels but simply want to copy the Span you entered for channel 2 for use in
another channel(s), press enter for Copy. The controller then asks whether you want to copy the value to all other
channels or to a selected channel.
Figure 9: Level Parameters
Tank Height?
QUICK CONFIGURATION PARAMETERS
At power-up in Level applications the parameters shown in
entering of the second transducer parameters or continues to auto assign channels. Selecting No completes the
configuration of transducers and begins measuring. Once the Auto Assign mode is initiated, select Yes or No to
Auto Set Pts, Auto Point Level, Auto PLC or Auto 4-20? In Auto Assign Mode, you are assigning the following
per enabled channel for each transducer, if the PCB's are installed:
Set Point: 1
4-20mA: 1
All are assigned sequentially. Press Enter to save. Quick Config is now completed.
Sensor 1
LIQUIDS
Up/Down/Enter
Sensor 1 App?
Level Type?
Transducer Freq
Operating Units
Decimal Pace?
Warning
Stand Pipe?
Warning
Set Temp?
Tank Height
Continue w/Setup?
4-20mA?
Warning:
sensor
perpendicular
to surface
If no temp
probe
detected
will appear. Selecting Yes allows the
Figure 9
36
www.bindicator.com
SON280020 Rev. C
Advertisement
Table of Contents
