3 . 9 . 7 S e t t i n g t h e P r i n t M o d e
The printer can be switched to operate in Thermal Transfer or
Direct Thermal mode with this setting.
Press the
/
buttons to select the TRANSFER or DIRECT
option. The default value is TRANSFER.
Press the ENTER button to confirm the setting and proceed to the
next screen.
3 . 9 . 8 C o n f i g u r i n g t h e P a p e r S e n s o r
The printer can be switched to operate in Thermal Transfer or
Direct Thermal mode with this setting.
Press the
/
buttons to select the TRANSFER or DIRECT
option. The default value is TRANSFER.
Press the ENTER button to confirm the setting and proceed to the
next screen.
3 . 9 . 9 C o n f i g u r i n g t h e P a p e r S e n s o r T y p e
This setting specifies which paper sensor is to be used: Gap
sensor (penetration sensor) and I-Mark sensor.
Press the
/
buttons to select between I-Mark or GAP
settings. The default value is I-MARK.
Press the ENTER button to confirm the setting and proceed to the
next screen.
GT Series Operator's Manual
Section 3: Configuration and Operation
Page 3-19