SATO GT424 Operator's Manual page 142

Section 6: Troubleshooting
Error No. LCD Message
17
18
19
20
21
Page 6-8
BCC Check error
Cause: BCC attached to sending data (for an item) is different
Remedy: Check the settings controlling data communication
Alarm sound: Three short beeps
External signal: Machine error
Item Number error
Cause: The sequence number of print data (for an item) does not
match the sequence number of the previously printed
data
Remedy: Check the settings controlling data communication
Alarm sound: Three short beeps
External signal: Machine error
Winding Full error
Cause(s): 1. The label rewinder needs to be emptied
2. The sensor is malfunctioning
Remedy: Remove the wound label. If the same error message per-
sists, contact a sales outlet, dealer, or service center
Alarm sound:
Three short beeps
External signal:
Machine error
Head Density error
Cause(s): 1. The print head has not been mounted properly in the
printer
2. An unsupported print head has been mounted
Remedy: Check that the print head is suitable for use with this
printer, and that the print head is mounted properly
Alarm sound: Three short beeps
External signal: No output
Kanji ROM error
Cause: Invalid Kanji data has been read from the Kanji ROM
Remedy: Make sure the Kanji ROM has been properly mounted. If
the same error message persists, contact a sales outlet,
dealer, or service center
Alarm sound:
Three short beeps
External signal:
Machine error
Description
GT Series Operator's Manual