ID-AL EventPlayer mkII EP220 User Manual page 22

ID-AL - EventPlayer mkII - Audio and DMX player - User manual
001[V-03].wav: decrease the volume level form 3 steps during the file playback.
At the end of the reading of the file, the volume level goes back to its previous level.
- If the variation values exceed the minimum or maximum values of the player, the levels are settled to
their maximum or minimum.
EP230 only
[Rxxx]
- Active or deactive the outputs contacts when play folder
l
Each file can operate the different outputs directly without any additional programming. You can light lamps,
operate motors or any other actions depending on the file play.
Attention, the state of the outputs can not evolve during the playing of the file. For this, you must
use the Show Control function.
Example :
001[R001] lion.mp3
002[R255] cat.mp3
004[R000] dog.wav
The values are between 000 and 255 following a binary progression. See the correspondence table in
the annexes.
The outputs are switched at the beginning of the file playback. If no other file has an option in its name,
the outputs will not change and will not be disabled.
If an event file is played (Show Control function), the outputs may change depending on the scenario of
the event file. We advise you to perform output switching in the Show Control scenario for more precise
control of information.
® Waves System
Active output 1 when play the file
Active the 8 outputs when the file
Deactive all outputs when the file
- 20 -
V 1.0 - 2018