ID-AL EventPlayer mkII EP220 User Manual page 18

ID-AL - EventPlayer mkII - Audio and DMX player - User manual
EP230 only
[Rxxx]
- Active or deactive the outputs contacts when play folder
l
Each file can operate the different outputs directly without any additional programming. You can light lamps,
operate motors or any other actions depending on the file play.
Attention, the state of the outputs can not evolve during the playing of the file. For this, you must
use the Show Control function.
Example :
001[R001] Active output 1 when play folder 001
002[R255] Active the 8 outputs when play folder 002
004[R000] Deactive all outputs when play folder 004
The values are between 000 and 255 following a binary progression. See the correspondence table in
the annexes.
The outputs are switched at the beginning of the folder playback. If no other file has an option in its name,
the outputs will not change and will not be disabled.
If an event file is played (Show Control function), the outputs may change depending on the scenario of
the event file. We advise you to perform output switching in the Show Control scenario for more precise
control of information.
® Waves System
- 16 -
V 1.0 - 2018