ID-AL EventPlayer mkII EP220 User Manual page 11

ID-AL - EventPlayer mkII - Audio and DMX player - User manual
3.3 - Contact output - EP230 Only
The EP230 player can control an output contact to switch on/off some peripherals like LEDs, small motors,
relays... The output is setup (on/off) by the name of the folder.
The contact output is an electronic switch named «MOSFET». (see schematic). You can control up to
60V / 500mA max device. You can't control device with high power. In this case, you need to use a relay.
Output schematic
® Waves System
Out x
G
You can use the 5V output to power an external
peripheral. Max 1A.
Example of a connection to control a LED in
direct or a relay with an external power supply.
Note: +V is a transfer of the main
external PSU. The provided power will
not exceed 500mA.
- 9 -
V 1.0 - 2018