SATO CL608VA Operator And Technical Reference Manual page 246

Appendix D: Optional Features
rewound on the spindle. The next label will only print after removing the current
label from the label exit path.
Note: The label dispenser will function only if it has been enabled using the front
panel switches (DSW3-1 and DSW3-2 in the ON positions).
The
label material. However, the use of labels with a substantially different opacity may
require that the threshold be adjusted. To adjust the threshold of the sensor, use the
following procedure:
1. Turn the
where the
see page 2-16) all the way clockwise. Turn the
position while simultaneously pressing the
release the
2. Make sure there is no label in the
counter-clockwise until the LED illuminates.
3. Place a label in the
it does not, turn the potentiometer clockwise until it goes off and repeat steps (b)
through (c).
4. Press the
to stop the printing and turn the printer OFF.
Page D-6
is adjusted at the factory for the optimal setting for most
connector is plugged into the front panel,
key.
key and the printer will print a test label. Press the
9001035 Rev. E
(located to the right of
to the ON
key. When the printer "beeps,"
. Turn the potentiometer
and check to see if the LED turns off. If
SATO CL Series Printers
key again