Label Dispense Option; Cl608 And Cl612 - SATO CL608VA Operator And Technical Reference Manual

LABEL DISPENSE OPTION

The CL608 and CL612
provides the ability to print labels in the "demand" mode. It is attached to rear of the
printer with two screws and is connected to the internal drive mechanism of the
printer. When the label dispenser is installed and configured for operation, the
printer dispenses one label at a time, peeling the backing from the label, which allows
for immediate application to the product by the operator.
Operator Setup
The following steps should be taken to set up the
1. Install the option using the instructions provided with the unit. The installation
time is approximately 30 minutes.
2. Power the printer ON.
3. The printer must be configured to used the label dispenser option. Switches
DSW3-1 and DSW3-2 on the front panel are used to configure the printer. To
enable the dispenser, both
4. Remove enough labels from the backing paper to provide 24 to 30 inches of
backing free from labels.
5. Open the
in the normal manner.
6. At the label exit area, feed the backing paper down and behind the
, then back down and around the
7. Feed the backing paper out the slot in the bottom rear of the printer and attach to
the
Knurled
Roller
SATO CL Series Printers
assembly and feed the backing paper through the print area
.
Backing
Roller
Label Dispenser Routing, CL608/CL612
9001035 Rev. E
Appendix D: Optional Features
is an external mechanism that
and should be in the
.

CL608 and CL612

.
position.
Backing
Rewind
Spindle
Page D-3