SATO CL608VA Operator And Technical Reference Manual page 245

the way.
7. Open the
normal manner.
8. Route the label backing down the front of the print mechanism and around the
9. Wrap the backing under and around the
under the two retainer prongs.
10. Manually turn the
the slack in the backing.
11. Swing the
12. Close the
12. Close the
13. Close the
14. To remove the backing from the
the green
the two retainer prongs, allowing the label backing to be easily removed and
discarded.
General Operation
Send your data stream in the normal manner to the printer. Labels should print one
at a time, even if your print quantity command requests more than one label. As the
labels are printed and presented for the operator to remove, the backing paper will be
Idle
Roller
Drive Roller
SATO CL Series Printers
latch until it releases and swing the
and feed the backing paper through the print area in the
.
back into position until the
engages.
until the magnetic latch engages.
.
.
. This will slide the rolled-up backing out from under
Label
Backing
Label Dispenser Routing, CL408/CL412
9001035 Rev. E
Appendix D: Optional Features
, routing it
counter-clockwise to take up all
, pull outward on
Backing
Take-Up
Spindle
out of
Page D-5