Print Size - SATO CL608VA Operator And Technical Reference Manual

1. Use the LINE key to step the underline cursor to either the YES or NO selection.
The default position is NO.
2. Once the correct setting is underlined, pressing the FEED key will advance the
display to the OFF LINE mode if YES was underlined or back to the Zero Slash
display if NO was selected.
User Test Print
This option allows you to print a test label. It is recommended that you print a test
label after you have changed any of the settings in the Advanced Mode. The test label
allows you to verify that you indeed did make the desired changes. To enter the User
Test Print Mode, power the printer on while pressing the FEED key. The printer will
"beep." Release the FEED key and the printer will display the following message on
the LCD panel:
1. Use the LINE key to step the underline cursor to either the LARGE or SMALL
selection. If LARGE is underlined, a label will be printed for a maximum width
label (6.5"). The default position is LARGE.
If LARGE was selected, a label containing a head check pattern and the current
printer setting information will be printed.
2. Once the desired label size setting is underlined, pressing the FEED key will cause
a label to be printed if LARGE was underlined. If SMALL was underlined, the
display will advance to the Print Size display.

Print Size

If SMALL was selected, the Print Size message will be displayed. You must enter the
size of the label. The minimum label size that can be selected is 4 cm (1.6") and the
maximum size is determined by the printer model as listed in the table below.
Pressing the LINE key will increment the setting by 1 cm for each time the key is
pressed. Once the maximum size is reached, the display will wrap arond and start
incrementing at 04 cm again. Once the correct label width is selected, pressing the
FEED key will initiate the print. The SMALL label only contains a head check pattern.
SATO CL Series Printers
USER TEST PRINT
LARGE
CL608
Max Label Width 16 cm
PRINT SIZE
9001035 Rev. E
Section 2. Installation and Configuration
SMALL
CL612 CL408
16 cm 10 cm
04 cm
CL412
10 cm
Page 2-37