SATO CL608VA Operator And Technical Reference Manual page 102

Section 4. Programming Reference
Special Notes
Horizontal
Page 4-32
1. Use the Print Position commands (V and H) to locate the new area
for the duplicate image (see page 4-59).
2. Position of the new target area must not be inside the original
image.
3. If you use the Rotate command, V, H, X and Y axes will be
reversed.
4. If the reference area of the target image exceeds the print area, it
will not be printed.
5. The allowable ranges for these fields are as follows:
CL408
0001
aaaa to
cccc 0832
Vertical 0001
bbbb to
dddd 1424
9001035 Rev. E
CL412 CL608
0001 0001
to to
1248 1216
0001 0001
to to
2136 1424
SATO CL Series Printers
CL612
0001
to
1984
0001
to
2136