Cutter Command - SATO CL608VA Operator And Technical Reference Manual

Command Structure
Command Function
Input to Printer:
Printer Output:
Special Notes
SATO CL Series Printers

Cutter Command

<ESC><NUL>aaaa
<ESC>~aaaa
aa = Number of labels to print between each cut (01-9999)
Example: <ESC><NUL>0002
Placement: Following the Print Quantity command <ESC>Q
Default: <ESC><NUL>0001 (if cutter enabled)
To control the cutting of labels when using a SATO cutter unit with
the printer printer. This command allows the cutting of a multi-part tag
or label at a specified interval within a print job.
<ESC>A
<ESC>H0020<ESC>V0020<ESC>WB1TEST LABEL<ESC>Q3
<ESC><NUL>0002
<ESC>Z
This set of commands will print 6 labels (3 x 2) with two labels
between each cut.
1. You must have the optional printer Cutter to use this function.
Contact your SATO representative for more information.
2. To use this command, the printer configuration must have the cutter
option enabled. See Printer Configuration in Section 2 of this
manual.
3. If the cutter option has been enabled in the printer configuration
and the cut value (aa = 00), the cutter is inactive.
The <NUL> represents the ASCII 00 Hex character. A "~" (tilde)
characte may be substituted for the <NUL> character in this
command.
4. When using the Cutter command, the total number of labels printed
is the product of the cut value and the print quantity. For example,
if the cut value is 2, and the print quantity is 20, then 20 sets of
two labels will be printed.
9001035 Rev. E
Section 4. Programming Reference
Page 4-33