Getting Started; Turn On The Watch (First-Time Use Only); Batteries - Oregon Scientific TS1X0 series User Manual

GETTING STARTED

TURN ON THE WATCH (FIRST-TIME USE ONLY)

Press MODE key for 2 seconds or more to activate the
LCD Display

BATTERIES

All batteries are included and already installed. Refer to the
Specifications page for battery types (
NOTE
To avoid the possibility of permanently damaging the
watch, we strongly recommend that you take your watch to a
local retailer or jeweler to have the watch battery replaced.
To load new batteries in the watch:
Diagram Instructions
1. Remove the Lycra strap.
2. Remove the back cover with a small Phillips
3. Install the battery by matching the correct polarity.
4. Replace the cover, screws, screw pin, and
5. Check that replacement batteries are fitted properly
28).
screwdriver.
Always use the correct battery type.
Warning: Reversing the polarity may damage the
product.
watchband. (Be sure to replace the O ring
properly).
by pressing a button. You should hear a beep.
To load new batteries in the chest belt (TS120 and TS130
only) and bike mount:
NOTE
The chest belt will stop sending signals if its battery is
low. Bad transmission from the chest belt may also be the result
of poor contact with the skin, surrounding interference, or
placing the receiver watch too far away.
Diagram
To load new batteries in the bicycle sensors and bike
mount:
NOTE The sensors will stop sending signals to the watch if
their batteries are low.
Diagram
NOTE
Replace the batteries whenever the HIGLO backlight
dims or stops working, or when you see the low battery icon.
7
Instructions
1. Insert a coin into the grove. Turn counter-clock-
wise.
2. Insert the battery. Match the correct polarity.
3. Replace the battery compartment. Tighten into
place.
Instructions
1. Insert a coin into the grove and turn counter-
clockwise.
2. Remove the battery. Remove the battery and
insert a new one.
3. Replace thebattery holder and compartment lid.
Tighten into place.