Table of Contents
Advertisement
GETTING STARTED
TURN ON THE WATCH (FIRST-TIME USE ONLY)
Press mode key for 2 seconds or more to activate the LCD
Display
BATTERIES
All batteries are included and already installed. Refer to the
Specifications page for battery types (➔ 27).
NOTE
To avoid the possibility of permanently damaging the
watch, we strongly recommend that you take your watch to a
local retailer or jeweler to have the watch battery replaced.
To load new batteries in the watch:
Diagram
Instructions
1. Remove the watchband and screw pin.
2. Remove the back cover with a small Phillips screw-
3. Install the battery by matching the correct polarity.
4. Replace the cover, screws, screw pin, and watchband.
5. Check the replacement batteries are fitted properly
driver.
Always use the correct battery type.
Warning: Reversing the polarity may damage the
product.
(Be sure to replace the O ring properly).
by confirming there is a key tone (beep).
To load new batteries in the chest belt
only) and bike mount:
NOTE
The chest belt will stop sending signals if its battery is
low. Bad transmission from the chest belt may also be the result
of poor contact with the skin, surrounding interference, or
placing the receiver watch too far away.
Diagram
To load new batteries in the bicycle sensors
NOTE
The sensors will stop sending signals to the watch if
their batteries are low.
Diagram
Replace the batteries whenever the HIGLO backlight
NOTE
dims or stops working, or when you see the low battery icon.
7
(RS107
Instructions
1. Insert a coin into the grove. Turn counter-clock-
wise.
2. Insert the battery. Match the correct polarity.
3. Replace the battery compartment. Tighten into
place.
(RP107
Instructions
1. Insert a coin into the grove. Turn counter-clock-
wise.
2. Remove the battery and insert a new one.
3. Replace the compartment. Tighten into place.
and
RP107
0nly):
Advertisement
Table of Contents
