Activate Tour Mode; Record Markers In Tour Mode; Pause Tour Mode - Oregon Scientific TS1X0 series User Manual

Recording Total Memory Recording time (hours)
Interval TS130
5 sec 11
20 sec 44
40 sec 88
60 sec 132
120 sec 264
240 sec 527
The watch can record and store up to 99 different trips,
providing there is enough remaining memory.
Default sampling time for readings in TOUR Mode is every 5
seconds. To increase the gap between samplings, and thus
increase the memory capacity, you can adjust this setting
through the PC software.

ACTIVATE TOUR MODE:

For best results, perform these steps im-
mediately before you begin your trip.
1. Simultaneously press FUN/SET and
MODE. The TOUR END screen will
display.
2. Press and hold FUN/SET for 2 sec-
onds. The TOUR number (M1, M2, etc.) will show at the
bottom of the display. You are now recording information.
The percentage (%) at the top indicates the total used
memory.
3. To stop the TOUR, press and hold FUN/SET for 2 seconds.
END will show at the bottom of the display. The Tour data will
be stopped.
TS120 TS110
8 6
34 23
68 47
102 70
203 140
406 280
4. To begin another TOUR, press and hold FUN/SET for 2
seconds. The new TOUR number (M3, etc.) will show at the
bottom of the display. You are recording information again.
5. Press MODE to return to the CLOCK display.
NOTE
Used watch memory is given as a percentage. It is
recommended that you download information to your PC and
clear all TOUR memories when this figure approaches 100%.
When the used memory hits 100% it will no longer record, and
any future readings will not be recorded.

RECORD MARKERS IN TOUR MODE

The marker function is used to mark a particular position during
a TOUR. To place a marker in TOUR Mode, press and hold
MARKER/LIGHT until the watch beeps.
NOTE The marker will only be shown in the PC data, once it
has been downloaded from the watch.

PAUSE TOUR MODE:

1. If you are not already in TOUR Mode,
simultaneously press FUN/SET and
MODE. The TOUR number will dis-
play. The percentage (%) at the top
indicates the total used memory.
2. Press FUN/SET. REST shows at the
bottom of the display.
3. Press SELECT/+ or press and hold FUN/SET for 2 seconds
to turn the rest on (paused) or off (recording).
15