Clock Mode; Set Clock; Set The Alarm; Stopwatch - Oregon Scientific TS1X0 series User Manual

CLOCK MODE

The time, date (including the day of the week) and time alarm
can be set while the watch is in CLOCK Mode. Follow the
instructions below to set or activate the time, date, alarm time,
stopwatch and timer.

SET CLOCK:

1. Press MODE to display the CLOCK Mode.
2. Press and hold FUN/SET for 2 seconds. "24h" will flash on
the display.
3. Press ST/SP/- to change from 24 hour to 12 hour time
display.
4. Press FUN/SET again. The hour will flash. Press
SELECT/+ to move the value up, or ST/SP/- to move the
value down.
Tip: Continuously press and hold a button to fast-change
the value.
5. Repeat Steps 3 – 4 to change the rest of the settings, in this
order: hours, minutes, year, month, and day.
NOTE You cannot change these settings while in TOUR
Mode. If you attempt to do so, TRIP will show on the display.
Refer to the TOUR Mode section ( 14).

SET THE ALARM

1. Press MODE to display the CLOCK mode.
2. Press FUN/SET to display the Alarm screen.
3. To turn the alarm on or off, press SELECT/+.
4. To change the alarm settings, press and hold FUN/SET for
2 seconds, Then, use the SELECT/+ or ST/SP/- buttons to
change the hour. Press FUN/SET to switch to minutes, and
use SELECT/+ or ST/SP/- to change the values. Press
FUN/SET again when you are finished.

STOPWATCH

The Stopwatch works in CLOCK, ALTI, PULSE, and BIKE
Modes. From any of these Modes, press SELECT/+ to display
the stopwatch. Then,
• Press ST/SP/- to start, pause, and
stop the stopwatch.
• With the stopwatch stopped, press
ST/SP/- again to reset.
NOTE
You can switch to other Modes
while running the stopwatch in the back-
ground.
9