3. Adjusting the height of the knee lifter
Warning: Turn OFF the power before starting the work so as to prevent
accidents caused by abrupt start of the sewing machine.
4. Installing the thread stand
MP02300EN_170818
1. The standard height of the presser foot
lifted using the knee lifter is 10mm.
2. You can adjust the presser foot lift up to
15mm using knee lifter adjust screw ①.
Caution: Do not operate the sewing
machine state that the presser foot ③ is
lifter 10mm or more since the needle bar
② in contact with the presser foot ③.
1. Assemble the thread stand unit, and insert
it in the machine table.
2. Tighten locknut ① to fix the thread stand.
3. For ceiling wiring, pass the power cord
through spool rest rod ②.
ANITA ©
6