Atd 5200 Warnings - ATD Tools ATD-5200 Owner's Manual

WARNING:
Always use air hose and couplings with a minimum working pressure ra ng of at least
1 1/2 mes the maximum working pressure ra ng of the tool.
WARNING:
Do not depress the tool trigger/lever when conne ng the air supply hose.
WARNING:
Do not lock, tape, wire, or otherwise disable the "ON/OFF" valve in the "ON" posi on.
The trigger must always be free to return to the "OFF"
WARNING:
When the tool is not in use, shut
the air supply line. If the tool is not to be used for a period of me, rst lubricate, disconnect from the air
supply and store in a clean and dry loca on at average room temperature.
NOTE:
Always use clean, dry air. Dust, corrosive fumes and/or water in the airline will cause damage to the tool.
Drain the air tank daily. Clean the air inlet lter screen on at least a weekly schedule. The recommended
hook up procedure can be viewed in the above diagram.
ATD 5200
INSPECTION:
Check for worn parts, air leaks, and damaged, loose or missing parts before opera ng. Check tank
opera on by conne
ow coming from nozzle/hose assembly. An annual tank/component insp
WARNING:
Failure to heed the following may result in personal injury and/or property damage.
NEVER leave unit una ended when opera ng or evacua ng.
NEVER use near open ame or heat source.
ALWAYS raise drain bowl and close main valve before emptying.
ALWAYS disconnect air supply a er emptying.
NEVER use unit for handling highly vola le fuels and uids.
USE ONLY the nozzle assembly provided.
DO NOT tamper with or remove the pop o valve and preset, non adjustable regulator as they
have been installed for protec on.
Typical Air Supply Instal
Warnings:
air to air nipple and closing ball valve. Verify that there is su cient air
when released.
the air supply and press the trigger/lever to drain
on
on is recommended.