Supported Boss-S1 Cli Commands - Dell EMC Boot Optimized Server Storage-S1 User Manual

6 Enter the directory cd /opt/Marvell and run the command at the CLI normally.
NOTE: ESXi 6.5 U1 or ESXi 6.0 U3 P06 is the minimum requirement to install the BOSS-S1 CLI utility.

Supported BOSS-S1 CLI commands

The following table lists the supported BOSS-S1 command line interface (CLI) commands. For more information about the commands, type
> help.
NOTE: The BOSS-S1 CLI utility only supports the following commands:
Table 5. Supported CLI commands
CLI commands
info -o hba
info -o vd
info -o pd
smart -p <PD_ID>
NOTE: SMART reports the health status of the M.2 disks. Refer to the SMART status return once the command is executed.
event
NOTE: There may be inconsistency in the events that are listed in BOSS CLI and other management interfaces that include
Dell EMC Open Manage Storage Services.
flash
help
26 BOSS-S1 CLI commands
Description
Display BOSS-S1 controller
information.
Display virtual drive information.
Display physical drive information.
Display SMART information of
physical drive.
Display controller events.
Enables you to perform controller
firmware upgrade.
Details help for all commands or for
only one command.
Windows Usage
mvsetup info -o hba
mvsetup info -o vd
mvsetup info -o pd
mvsetup smart -p 0
mvsetup event
mvsetup flash -a update -f
<image binary file> -t raw
mvsetup help info
Linux / VMware Usage
./mvcli info -o hba
./mvcli info -o vd
./mvcli info -o pd
./mvcli smart -p 0
./mvcli event
./mvcli flash -a update -f
<image binary file> -t raw
./mvcli help info