..............2 oNtraiNdiCatioNs ................2 arNiNgs ................3 autioNs ............3 dditioNal NforMatioN .............. 4 haraCteristiCs ..............4 arts of the ..............5 ittiNg the ............5 isasseMbliNg the ..........6 leaNiNg the ask iN the ........6 eProCessiNg the ask betWeeN atieNts ............
nV M ™ on the ability of the patient to open his or her ltra iraGe mouth. The U NV M ™ system (non-vented) is ltra irage • If the patient might fail to respond effectively to only indicated for the treatment of adult patients using failure of the ventilator by opening his or her non-invasive ventilator systems that have an active mouth and breathing through the mouth, this...
(eg volume-cycled dditional nforMation ventilators with no compensation for leak, or pressure-cycled ventilators which are unable ResMed has tinted the U NV M • frame ltra irage...
enVironMental conditions haracteristics Temperature Humidity Mask deadsPace NV M Operating +41°F to 104°F 15% to 95% 100 mL ltra irage (+5°C to +40°C) relative humidity Note: This value was obtained using a facial profile and non-condensing measuring the volume from the surface of the face to the end of Storage and Transport -4°F to 140°F up to 95%...
Turn the ventilator on. Lie down and check that ittinG the the mask is comfortable and there are no air leaks. Note: Before fitting the mask, refer to section on “Cleaning the If there are air leaks, you may need to readjust the Mask in the Home”.
It is important to always hand wash the headgear. Cleaning, disinfection and sterilization instructions Hand wash the headgear in warm, soapy water. are available from the ResMed website, www.resmed. Use a mild detergent such as pure soap. Rinse com/masks/sterilization/americas.
easseMblinG the Insert the ports cap into the ports. Make sure the tabs of the ports cap face away from the mask. Forehead Reconnect the forehead support to the mask Elbow frame. Depress the tab and move the forehead support into one of the four slot positions. Elbow clip Insert the elbow into the mask frame and secure...
Fit the grooved edge of the nasal cushion to the ccessories and ePlaceMent arts mask frame. Fit the top section first, then work Description Quantity Part your way around the mask, pushing the cushion per pack Number onto the frame, ensuring a good seal has been Cushion (Standard) 16556 achieved.
This warranty is only available to the initial consumer. refuse. It is not transferable. If the product fails under conditions of normal use, yMbols ResMed will repair or replace, at its option, the Caution, consult accompanying documents; defective product or any of its components. Batch Code; Catalogue Number;...
Page 11
ResMed shall not be responsible for any incidental or consequential damages claimed to have resulted from the sale, installation or use of any ResMed product.