F Itting The M Ask; Isassembling The Ask - ResMed Ultra Mirage Clinician Manual

f M
ittinG the ask
Note: Before fitting the mask, refer to section on "Cleaning the
Mask in the Home".
1
Connect the ventilator 22mm male fitting to the
mask elbow. Alternatively, do this after you have
fitted the mask (Step 3).
2
Place the cushion over your nose, pull the
headgear over your head and make the side lower
Velcro ® straps pass below your ears.
Use the Velcro straps to adjust the fit of the
headgear. Do not pull the straps too tightly.
3
The pads of the forehead support should lightly
touch your forehead when the mask is in place.
Adjust the forehead support by depressing its tab
and moving it to one of the other slot positions.
4
Turn the ventilator on. Lie down and check that
the mask is comfortable and there are no air leaks.
If there are air leaks, you may need to readjust the
Velcro straps (see Step 2) or forehead support (see
Step 3).
To remove the mask, depress the tabs of the headgear
clips. This releases the headgear clips from the mask
frame. Pull the mask and headgear away from your
head.
d M
isasseMblinG the
1
Detach and separate the ventilator 22mm male
fitting, headgear, headgear clips, forehead pads,
cushion clip, cushion, and ports cap.
2
Depress the forehead
support tab and move
it past the top slot
position. This allows
you to remove the
forehead support from
the mask frame.
ask
Forehead
support
5