Gage Bilt GB585NT User Manual

Installation tool

Advertisement

Quick Links

GB585NT
G A G E B IL T
M A D E IN U.S .A .
INSTALLATION TOOL
GAGE BILT Inc.
44766 Centre Court
Clinton Twp. MI 48038
e-mail:solutions@gagebilt.com / www.gagebilt.com
(586) 226-1500
(586) 226-1505 Fax

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GB585NT and is the answer not in the manual?

Questions and answers

Summary of Contents for Gage Bilt GB585NT

  • Page 1 GB585NT INSTALLATION TOOL GAGE BILT Inc. G A G E B IL T 44766 Centre Court (586) 226-1500 Clinton Twp. MI 48038 (586) 226-1505 Fax M A D E IN U.S .A . e-mail:solutions@gagebilt.com / www.gagebilt.com...
  • Page 2 - 40,000 lbs. DESCRIPTION The GB585NT is a hydraulic installation tool capable of installing 5/8" and 3/4" Magna-Grip® or standard lockbolts. It weighs just under 20 lbs. and is our most powerful hand tool. It has a 1.600" rivet setting stroke and a rated pull load of 40,000 lbs.
  • Page 3 WARNING Be sure there is adequate clearance for tool and operator's hands before proceeding as severe personal injury may result. WARNING Do not pull on pin without collar, as it will eject forcibly when pintail breaks off and severe personal injury may result.
  • Page 4 MAINTENANCE The performance of any tool depends upon good maintenance practices. Following these minimal requirements for service and care will extend the life of your tool. *Only use a hydraulic power source equipped with relief valves and pressures set within specified limits.
  • Page 5  APPLY REMOVABLE LOCTITE GAGE BILT P/N A-1006 Rev. 4/11...
  • Page 6 GB585NT Parts List Ref. No. Part Num ber Description Qty. 762006 Ejector Gland Assy. (Inc. 2-7) 750127 Wiper 762007 Ejector Gland 401080 Back-Up Ring 400779 O'Ring 401411 Quad Ring 585117 Washer Ejector 505022 Pintail Ejector 585123 Piston Assembly (Inc. 10-12)
  • Page 7 Perform overhaul in a clean, well lit area using care not to scratch or nick any smooth surface that comes in contact with an o'ring. Use of Lubriplate® (Gage Bilt part no. 402723) or other lubricant is recommended during reassembly to prevent tearing or distorting of o'rings.
  • Page 8 GB585NT - SELECTION CHART FASTENER DIA. NOSE ASSEMBLY LOCKBOLT 5/8" 20-585-41 HIGH TENSILE PULL TYPE 3/4" 24-585-46 C50L® 5/8" BOM20-585-41 BLIND OVERSIZE MANDREL 3/4" BOM24-585-46 5/8" HP20-585-41 HP8® 3/4" HP24-585-46 16mm HP20-585-41 MHP 10.9 *20mm HP20MM-585-46 C50L® AND HP8® ARE REGISTERED TRADEM ARKS OF ALCOA INC.

Table of Contents