Smart Payout Connection; Smart Ticket Connection; Checking The Supply Voltage; Communication With The Host - Innovative Technology NV200 Spectral User Manual

User Manual – NV200 Spectral
<< Back to Contents

8.3.3 Smart Payout Connection:

The Payout module connector is a 16-
pin molex as outlined in
ensure the cable is correctly seated.
If the TEBS cashbox is fitted it also
needs to be connected to power as
explained in the section above.

8.3.4 Smart Ticket Connection:

The SMART Ticket uses the same 16
pin molex connector as the SMART
Payout, additional pins need to be
populated to carry communications to
both the NV200 Spectral and printer.
More details of this can be found in
Section 6.2
An additional 4-pin molex connector is
required for power, both must be
connected before the unit will identify
as a Smart Ticket. When power is
supplied to the ticket the LED on the
rear will be illuminated.

8.3.5 Checking the Supply Voltage

If the power supply seems to be powered and connections to the unit are in place,
yet the unit isn't powered, check the voltage output from the power supply is
sufficient and the polarity is correct. If this isn't the issue replace the cable as it may
have been damaged. Should this not resolve the issue, contact your local repair
centre, details of which can be found on our website.

8.4 Communication with the Host

If there is no communication with the host check the communication cable, typically
this will be the IF17 and the port on the host system.
Ensure the cable is connected to the IF17 correctly, so the connectors are fully
seated, and the USB cable is connected to the computer.
Copyright © Innovative Technology Ltd 2018
Section 6.2,
Doc: User Manual NV200 Spectral
Version: 1.0
Page 57 of 76