Listening To The Radio; Storing Preset Stations; Recalling Preset Station - Sanyo DTA-2680 Instruction Manual

LISTENING TO THE RADIO

1.
Press the POWER/STANDBY button to turn the
system 'ON'.
2. Press the TUNER/BAND button to select the
radio function.
TUNER/
BAND
Example : FM mode
3. Press the TUNER/BAND button repeatedly to
select AM or FM band.
4.
Press the SKIP Forward or Backward buttons to
tune to the desired station.

STORING PRESET STATIONS

1. Tune to the station you wish to store.
The unit enables you to program 30 stations of FM
and 10 stations of AM band.
2. Press the PROG button once, and the preset
station number will be flashing.
3. Press the PRESET button repeatedly to set the
desired preset station number.
or
5. When finished listening, press the POWER button
Note: For AM reception, plug the supplied frame
antenna into the AM ANT jack. Then adjust the frame
antenna until it is in position with the best reception.
4. Press the PROG button again. The station is
5. To store other stations, repeat above steps.
FM
18
Auto tuning - Press the TUNING forward or
backward buttons momentarily and release. The
tuner will move forward or backward to the next
available station.
Manual Tuning - Press and hold the SKIP forward/
backward buttons until the display approaches your
desired station. Then tap the buttons repeatedly
until the display shows the exact frequency.
to shut the system OFF.
stored.

RECALLING PRESET STATION

Press the PRESET buttons to select the
desired station.
Note: When setting or recalling the preset station by
directly pressing the number, on remote control unit
to press key number 0, 1 to preset station 01; press
0, 9 to preset station 09; press 1, 5 to preset station
15.