Dismantling And Disposal; Safety Regulations For The Disassembling And Disposal; Disassembling; Disposal - CNC-Step T-Rex Series Operating Instructions Manual

Disma ntling and disposa l
10
Once the maximum lifetime of the machine is reached, the machine must be dismantled and
environmentally friendly disposed.
• Disassembly should only be performed by qualified personnel.
• Work on the electrical system may only be performed by qualified electricians.
1 0 .1 S a f e t y r e g u l a t i on s f o r t h e d i s a s s e mb l i n g a n d d i s p o s a l
Improper disassembling
WARNING:
Risk of injury from incorrect disassembly!
Residual stored energies, angular components, peaks and corners on or in the
machine or on the required tools can cause injury.
• Before starting any work ensure sufficient space.
• Take care with sharp-edged components.
• Maintain order and cleanliness in the workplace! Loosely stacked or
scattered components and tools are accident sources.
• Disassemble components professionally. Note partially high weight of the
components. If necessary, use lifting equipment.
• Secure components so they do not fall down or fall over.
• •If in doubt consult the manufacturer
1 0 .2 D i s a s s e mb l i n g
Before beginning with dismantling:
• Switch off the machine and secure against restart.
• Discharge all power supply from the machine, physically separate stored residual energy.
• Remove the operating and auxiliary materials and residual processing materials and dispose
environmentally friendly.
Then clean modules and components in a professional manner and in accordance with applicable
local safety and environmental regulations.
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Support: +49 (0)2831/91021-50
Operating Instructions
T-Rex-Series
Page 71
31.03.2014