Hidden Tig Functions; Measured Values; Tig Functions Explanation - ESAB Renegade ET 300i Instruction Manual

6 CONTROL PANEL
6.3.1

Hidden TIG functions

There are hidden functions in the control panel. To access the functions, press parameter
selection button for 3 seconds (see section SETTING PANEL for button placement). The
display shows a letter and a value. Select function by pressing the same button. The knob is
used to change the value of the selected function. To exit hidden functions, press the button
for 3 seconds again.
Letter Function
A Gas pre flow
b Slope up
I Remote min current
6.3.2

Measured values

Measured current
Measured value in the display for welding current A is arithmetic average value.
Measured voltage
Measured value in the display for arc voltage V is arithmetic average value.
6.4

TIG functions explanation

HF start
The HF start function initiates the arc by using a high frequency voltage pilot arc.
This will reduce the risk of tungsten contamination in the starts. The high
frequency voltage might disturb other electrical equipment in the surrounding
area.
LiftArc™
The LiftArc™ function initiates the arc when the tungsten electrode is brought
into contact with the workpiece, the trigger switch is pressed, and the tungsten
electrode is lifted away from the workpiece. In order to minimize the risk of
tungsten contaminations the start current is very low and will slope up to the set
current (controlled by the slope up function).
0463 416 001
Settings
0.0–9.9 s
0.0–9.9 s
0–99%
- 26 - © ESAB AB 2017