MOTO GUZZI California 1400 Custom Instruction Manual page 37

CALIBRATION
Select the CALIBRATION function from the configuration menu to access the CALI-
BRATION function.
When the CALIBRATION function is selected (with vehicle at a standstill), a screen is
shown with the following message at the bottom of the display:
CALIBRATING
To calibrate the MGCT (Moto Guzzi Controllo Trazione) system, ride about 10 seconds
on a flat, straight section of road in second gear at a speed of 30 +/- 2 km/h (18.64 +/-
02_31
1.24 mph) until CALIBRATION appears on the display.
NOTE
ONCE THE MESSAGE 'CALIBRATING' CEASES TO BE DISPLAYED, STOP THE
VEHICLE, TURN THE IGNITION SWITCH OFF AND LEAVE OFF FOR AT LEAST
30 SECONDS TO COMPLETE THE CALIBRATION PROCEDURE.
THIS ALLOWS THE CALIBRATION TO BE STORED IN THE MEMORY.
NOTE
CALIBRATION IS NEEDED TO OPTIMISE MGCT FUNCTIONALITY IN THE EVENT
OF CHANGING TYRE TYPE.
IF TYRES OTHER THAN THOSE INDICATED IN THIS USE AND MAINTENANCE
BOOKLET ARE USED, TO OBTAIN THE SAME PERFORMANCE FROM THE
MGCT SYSTEM THE SETTING LEVELS OF THE SYSTEM ITSELF MAY NEED TO
BE MODIFIED.
NOTE
TURN THE IGNITION SWITCH OFF TO ABORT THE CALIBRATION PROCE-
DURE.
WHEN CALIBRATION IS CARRIED OUT THE TRACTION CONTROL SYSTEM
AUTOMATICALLY DEACTIVATES (IF IT WAS PREVIOUSLY ACTIVATED).
CAUTION
WHEN THE MOTORCYCLE IS IN RESERVE, IT IS NOT POSSIBLE TO CARRY
OUT THE CALIBRATION PROCEDURE BECAUSE, DURING THIS PHASE, ON
37