ELECTRIC BICYCLE METER KT—LCD8S Product User Manual
After finishing C1 parameter setting, press
value and then press
○
C2 Motor Phase Classification Coding Setting
Enter C2 parameter setting interface after C1 parameter setting is finished, press
button (SW),C2 parameter column flashes.
C2 is motor phase classification coding setting, it is served as identification parameter
of different phases of the motor when using sine wave drive and the default value is 0.
When C2 setting is 0, indicating that the used Quantum motor phase is an ordinary one.
When the setting is a certain value, indicating a particular motor phase is used. C2 setting
range is 0-7, press
After finishing C2 parameter setting, press
01
Higher
02
Standard
button (DOWN) to enter C2 parameter setting interface.
C2 parameter setting interface
button (UP) or
- 27 -
button (SW) to save the current
button (DOWN) for selection.
button (SW) to save the current
06
Higher
07
Standard