Exit General Project Setting - SZKTDZ KT-LCD8S User Manual

ELECTRIC BICYCLE METER KT—LCD8S Product User Manual
After finishing the wheel diameter setting, press
metric/imperial units setting interface, press
speed and mileage unit flash. Press
make sync selection of three metric/imperial units as speed, mileage, and the environment
temperature.
Definition Table of Metric/Imperial Units：
Code Speed
0
1
2
3
Under the metric/imperial units setting interface, if there's no button operation
on the meter for more than 1 minute, and then the meter will automatically return to
display 1, and the original set units will be saved.
After finishing the metric/imperial units setting, press
save the current set values, and then speed and mileage units stop flashing, or hold
button (SW) long for about 2 seconds to exit the general project setting environment and
return to display 1.
○

Exit General Project Setting

Among the three general project settings, after each setting is completed, if hold
button (SW) long for about 2 seconds, all can exit the setting environment and return to
display 1, meanwhile, the current set parameters are saved.
Under each setting interface, if there's no button operation on the meter for more than
1 minute, and then the meter will automatically return to display 1, and the original set
Mileage
Km/h
MPH
Km/h
MPH
button (DOWN) to enter the
button (SW) shortly, and then the
button (UP) or
Km ℃(Centigrade temperature)
Mil ℃(Centigrade temperature)
Km
Mil
- 20 -
button (DOWN) shortly to
Ambient temperature
℉（Fahrenheit）
℉（Fahrenheit）
button shortly (SW) to