P4 Throttle Startup Setting - SZKTDZ KT-LCD8S User Manual

ELECTRIC BICYCLE METER KT—LCD8S Product User Manual
Enter P3 parameter setting interface after P2 parameter setting is finished,
and P3 parameter column flashes.
button
P3 is power assist control mode setting, when P3 parameter setting is1, power assist
control mode is gear 5 of "imitation torque control" mode, when P3 parameter setting is
0, power assist control mode is gear 5 of "speed control" mode. P3 parameter needs to be
determined according to the distributed function of the controller, its setting range is 0 or 1,
press button (UP) or
method is the same to that of P2.
After finishing P3 parameter setting, press
values, then press
○

P4 Throttle Startup Setting

Enter P4 parameter setting interface after P3 parameter setting is finished,
P4 parameter column flashes.
button,
P3 parameter setting interface
button (DOWN) for selection. P3 parameter setting
button (DOWN) to enter P4 parameter setting interface.
- 23 -
button (SW) to save the current set
press
press