Ripping; Table Tilt - Shop fox W1749 Owner's Manual

Table Tilt

The bandsaw table will tilt 45˚ to the right to provide a
range of cutting options.
To tilt the table, do these steps:
1. DISCONNECT BANDSAW FROM POWER!
2. Loosen the table tilt lock knob and the table adjust-
ment tension knob shown in Figure 42.
3. Tilt the table to the desired angle. Adjust the ten-
sion knob to move the table faster or slower. Use
the angle gauge for easy reference.
4. Tighten the table tilt lock knob.
Table
Adj.
Knob
Table Adj.
Tension Knob
Figure 42.Table controls.
-28-
W1749 9" Bandsaw
Angle
Gauge